Centromat Internal Alignment Clamps
Centromat Internal Alignment Clamps are specially designed for quick and accurate alignment and clamping of flanges, nozzles, short pipe sections etc to pipes and cylindrical tanks.
- Locating rails for right angle abutments
- Automatic diameter compensation (even for widely varying pipe diameters)
- No need for additional adjustments
- The internal clamp allows free access so that all parts can be welded
- Locating rails available in VA
- Special models available
| Size | Clamping Range (mm) | Weight (Kg) |
| 1 | 54 - 140 | 1.25 |
| 2 | 85 - 220 | 3.60 |
| 3 | 120 - 350 | 10.50 |
| Size | Clamping Range (mm) | Shaft Length (mm) | Weight (Kg) |
| 1 | 54 - 140 | 120 | 1.35 |
| 2 | 85 - 220 | 150 | 4.00 |
| 3 | 120 - 350 | 190 | 11.00 |
|
Table with all measurements available on request |
|||
| Size | Clamping Range (mm) | Weight (Kg) |
| 1 | 54 - 140 | 1.10 |
| 2 | 85 - 220 | 2.50 |
| 3 | 120 - 350 | 6.00 |
| 4 | 180 - 520 | 14.00 |
| 4/s | 400 - 940 | 20.00 |
| Table with all measurements available on request (s = double expanding device) | ||
Type 4
This model has two independent expanding clamps allowing coaxial alignment of two hollow cylindrical components of different diameters.
The first expanding clamp is inserted and clamped inside the pipe by means of the knob. Then the other weld part (eg the flange) is placed over the top expanding clamp and clamped by means of the hand-bar.
Specially suited to heavier parts than type 3 (above)
- Locating rails available in VA
- Special models available
| Size | Clamping Range (mm) | Weight (Kg) |
| 1/e | 54 - 140 | 1.30 |
| 2/e | 85 - 220 | 3.90 |
| 3/e | 120 - 350 | 11.65 |
| 4/e | 180 - 520 | 27.00 |
| 4/e/s | 400 - 940 | 39.00 |
| Table with all measurements available on request (s = double expanding device) | ||
Type 5
This internal alignment clamp has two independent clamps. Used for clamping flanges of all kinds and similar parts to elbows and pipe-ends of various diameters.
The lower expanding clamp has strong gripping feet which insert into the bend and are tightened by means of the knob. The top expanding clamp is tightened by means of the hand-bar in the flange.
- Locating rails available in VA
- Special models available
| Size | Clamping Range (mm) | Weight (Kg) |
| 1/b-e | 54 - 115 | 1.00 |
| 2/b-e | 85 - 195 | 3.30 |
| 3/b-e | 120 - 315 | 9.50 |
| 4/b-e | 180 - 520 | 23.10 |
| Table with all measurements available on request | ||
